Fulgor Milano FCPO 6215 P TEM Instructions Pour L'installation Et L'utilisation page 71

4. Slide out the internal glass as shown below. Pull out the second and
third glass panels (intermediate panels) to clean them.
5. Replace the middle panes after cleaning in reverse order,
checking that they are oriented so the words INTERNAL SIDE
are properly legible.
NOTE: a slight gap between the middle panes and the side
supports is normal because it allows for the heat expansion
of the glass.
6. Place the inner glass between the two uprights and put the upper strip
back in place.
Replacement of the oven light
WARNING
Make sure that:
• The oven and lights are cool and power to the oven has been turned off
before replacing the light bulb(s). Failure to do so could result in electrical
shock or burns.
• The lenses must be in place when using the oven.
• The lenses serve to protect the light bulb from breaking.
• The lenses are made of glass. Handle carefully to avoid breakage. Broken
glass could cause an injury.
3
1
2
(230V - 25W G9)
(230V - 15 or 25W)
2
3
1
1 Turn off power at the main power supply (fuse or breaker box).
2 Remove the lens (1).
3 Remove the light bulb (2) from its socket (3).
4 Replace the bulb (2) with a new one. Avoid touching the bulb
with fingers, as oils from hands can damage the bulb when it
becomes hot.
5 Use one with the same Volt and Watt (see figure).
6 Screw the lens (1) back on.
7 Turn power back on at the main power supply (fuse or breaker
box).
EN
1
2
(230V - 25W G9)
33