Fulgor Milano FCPO 6215 P TEM Instructions Pour L'installation Et L'utilisation page 69

To Set the Self-Clean Mode
1. Press key and confirm with key
2. A message appears on the screen to remove all objects or
accessories from the compartment.
3. Press the key to start door lock and cleaning cycle.
4. The clean time is displayed automatically, its standard value is 3
hours.
SELF CLEAN
11:00 am
5. At the end of the programmed cleaning time, the oven will
automatically turn off.
• To stop the cleaning mode at any moment, press
• The Self Cleaning cycle cannot be selected if the door is
open.
• If the door is in the open position when the function has
already been selected and the
doesn't move, the "PADLOCK" icon will flash until the door
will be closed and the lock motor stops. When the "CLOSED
PADLOCK" it is displayed, the door cannot be opened.
• Check that the door has been locked, if door does not lock,
press key and do not start self-clean; phone for service
• Do not attempt to open the door while the cleaning cycle is
running and the door is locked.
To Change the Cleaning Time
1. To change the setting from 3 hours, select either 2 hours for light
soil immediately after starting.
2. To change the hours, touch the
with the key (the hours will flash), use
the value, then press to confirm the new value.
3. To select the minutes, touch the
or keys to change the value, then press
new value.
.
END
STOP
4:30 pm
START
Start
1:30 pm
key.
key is pressed the latch
key, select and confirm
or keys to change
key (the minutes will flash), use
to confirm the
19 - Setting The Self Cleaning Mode
To Delay the Start of Cleaning
1. Follow steps 1 through 3 above.
2. Touch the key and verify that "STOP TIME" appears on
the display. The hours will begin flashing, use
change the value, then press
3. To select the minutes, touch the
use or keys to change the value, then press
the new value.
SELF CLEAN
11:00 am
8. When the delay time expires, self-cleaning will start.
9. At the end of the programmed cleaning time, the oven will
automatically turn off.
CAUTION
Keep in mind that the oven door will remain locked until it is safe
enough to open. The lock symbol will disappear from the display
when the door lock is released.
You will still need to exercise caution when the door lock is
released because the inside of the oven may still be hot.
After the self-clean cycle is complete the oven control monitoring the
internal temperature and the following messages will be displayed:
• From the 460°C/860°F to 270°C/518°F= "End Self Cleaning"
• From the 270°C/518°F to 50°C/122°F= "Waiting to Clean"
• From the 50°C/122°F to 25°C/77°F= "Remove Residues" (Press ON/
OFF key to clear the message).
You may notice a powder ash residue in the bottom of the oven
after self-cleaning. This condition is normal. Use a damp cloth or
sponge to wipe up the residue after the oven cools down.
Self-cleaning Tips:
• If any soil remains in the oven after the self-clean cycle is complete, you may
repeat the cycle if you want.
• Self-clean the oven regularly to prevent excessive soil build-up. Doing so will
make the self-clean cycle work better and reduce smoke and odors.
or keys to
to confirm the new value.
key (the minutes will flash),
to confirm
END
STOP
2:00 pm
TIME
TIME
03:00
EN
31