Publicité
Les langues disponibles
Les langues disponibles
3.4.
Cleaning and maintenance
a)
After each use or after finishing work, remove the remnants of the material to
be cut, such as cuttings, shavings, etc.
b)
Pull the mains plug and let the unit cool down completely before cleaning,
adjusting or replacing accessories and when the unit is not in use.
•
Wait until the rotating parts stop.
c)
Use only non-corrosive cleaning agents for cleaning the surfaces.
d)
Store the unit in a dry and cool place protected from moisture and direct
sunlight.
e)
Do not spray the unit with a stream of water or immerse it in water.
f)
Make sure that no water enters through the ventilation openings in the casing.
g)
Clean the ventilation openings with a brush and compressed air.
h)
Perform regular inspections of the unit checking technical fitness and any
damages.
i)
Do not use sharp and/or metal objects (e.g. wire brush or metal spatula) for
cleaning as they may damage the surface of the appliance material.
j)
Do not clean the device with acidic substances, medical products, thinners,
fuel, oil or other chemicals as this may damage the device.
k)
Replacing the rubber guide on the drive roller on the motor side:
If the properly tensioned blade slips or does not fit properly on the roller on
the motor side, replace the rubber blade guide.
1. Roller
2. Rubber guide (cross section)
3. Edge of the rubber guide
l)
Replacing the motor carbon brushes:
The carbon brushes of an electric motor wear out over time and this is a
standard wear part. The device comes with an additional pair of brushes.
Publicité
