Publicité
Les langues disponibles
Les langues disponibles
This function allows the user to restore the handset setting to the factory default.
1.
Press OK key, then using ▲ or ▼ key to select HS DEFAULT item.
2.
Press OK key to confirm.
3.
The display shows PIN?, then key in the PIN code (default 0000).
4.
Press OK key to confirm. If the PIN code is validated all handset settings will be returned to the factory
default.
Handset Menu function 5: REGISTRATION
Maximum 5 handsets can be linked to the same base unit by the follow ways,
Maximum 4 bases can be linked to the same handset by the follow ways:
1.
In standby mode, press OK key, then using ▲ or ▼ key to select REGISTERATION item.
2.
Press OK key to enter. Press ▲ or ▼ key to select BASE from BASE1, BASE2, BASE3 or BASE 4.
3.
Press OK key to confirm, LCD displays PIN? Then enter the pin code (defaulted as 0000, if input wrong
number, press R to delete).
4.
When finished press OK key to confirm. LCD display SEARCHING, then press and hold
you has get DI-DU- DU- sound. The handset and base have registration successfully.
Notes:
1.
If the handset and base is fail to registration successfully, the handset will return to the standby mode.
2.
You can repeat the above steps to register another handset for the same base, and the successfully
registered handset will displays HS2 or HS3 on the LCD according to the registration sequence.
3.
Press
key to page the handset when difficult to look for.
OPERATION
Speakerphone operation & volume control
Press
key once to obtain a dial tone, dial your number, when you hear the called party answers the
phone, you can begin your conversation. You can also answer an incoming call by pressing the
once. Press
and
During the speakerphone operation, the user can adjust the speaker volume level by pressing the ▲ or ▼
key. Total 6 levels for selection.
If you press
key to use earpiece, you can press the ▲ or ▼ key to adjust the earpiece volume, total 5
levels for selection.
Mute the mouthpiece
During a call, press OK key once to mute the mouthpiece and MUTE will show on LCD. Press OK key again
to get back to the call and the MUTE will disappear.
Caller ID – type I & II
TYPE I
After you have applied the caller ID service, you can see the caller party phone number during an incoming
ring.
TYPE II
During the conversation, the phone number of the incoming call of the second caller can be seen in the unit.
This function can be worked when the user applied the Telecom service.
Flash function
When dial a number and the line is busy, press R key and then press
Pause
All manuals and user guides at all-guides.com
key or put the handset on the base to hang up.
key to dial it out again.
30
key until
key
Publicité
