Télécharger Imprimer la page

Husqvarna K1 PACE Notice D'utilisation page 35

Masquer les pouces Voir aussi pour K1 PACE:

Publicité

Les langues disponibles

Les langues disponibles

Troubleshooting of the product
Note:
For troubleshooting of the battery and the
battery charger refer to related operator's manual.
Symbol on the control pan-
el
1598 - 006 - 06.09.2023
Troubleshooting
Problem
The product does not start.
No LEDs come on when
you push the On/Off but-
ton.
No reaction from the motor
when you push the power
trigger.
The motor makes a sud-
den movement when you
push the power trigger,
then stops.
The product stops when
you apply work load.
The product operates but
there is no indication light
on the control panel.
The warning indicator
flashes red. Temporary
warning.
The red warning indicator
is on
Cause
The battery is empty.
The battery is not correctly
installed in the product.
The battery is damaged or
does not operate correctly.
Dirty or damaged plug be-
tween battery and product.
Servicing is necessary.
Servicing is necessary.
Servicing is necessary.
You have put too high load
on the product.
Servicing is necessary.
Temperature deviation, if
the temperature warning in-
dicator is also on.
Damaged battery.
Incorrect direction of rota-
tion.
The power trigger is push-
ed during startup.
The power trigger and the
On/Off button are pushed
at the same time.
Servicing is necessary.
Solution
Charge the battery.
Remove the battery and in-
stall it correctly.
Push the On/Off button to
do a check of the battery.
A minimum of 1 green LED
must come on.
Make sure that the pow-
er connectors between the
battery and the product are
not dirty or damaged.
Speak to an approved
Husqvarna service center.
Speak to an approved
Husqvarna service center.
Speak to an approved
Husqvarna service center.
Start the product and use
less load.
Speak to an approved
Husqvarna service center.
Let the product cool down if
it is too hot. If it is too cool,
put it indoors to warm up.
Replace the battery.
The product stops. Pull the
power trigger to reset.
Release the power trigger
during startup.
Release the power trigger.
Speak to an approved
Husqvarna service center.
35

Publicité

loading

Ce manuel est également adapté pour:

K1 pace rescueK1 pace rail