Husqvarna K1 PACE Notice D'utilisation page 17

WARNING:
blades to cut plastic material. The hot
diamond blade can melt the plastic, which
can cause a kickback.
• Diamond blades have a steel core with segments
that are made of industrial diamonds.
• Diamond blades are used for masonry, reinforced
concrete and stone.
• Make sure that the diamond blade rotates in the
direction of the arrows shown on the diamond blade.
• Always use a sharp diamond blade.
• Diamond blades can become blunt if you use an
incorrect feeding pressure or when you cut materials
such as hard reinforced concrete. If you use a blunt
diamond blade it becomes too hot, which can cause
the diamond segments to come loose.
To sharpen the cutting blade
Note:
For the best cutting results, use a sharp cutting
blade.
• To sharpen the cutting blade, cut into soft material,
such as sandstone or brick.
Diamond blade - requirements
WARNING:
segment (T1) is wider than the blade (T2).
This is to prevent pinching in the cutting slot
and a kickback.
1598 - 006 - 06.09.2023
Do not use diamond
Make sure the diamond
T1
T2
WARNING:
blades with positive rake angles.
WARNING:
blades with greater gap between segments
than max 10 mm (A).
A
WARNING:
blades with greater blade thickness than
recommended maximum, refer to
data on page 38 .
Do not use diamond
Do not use diamond
Do not use diamond
Technical
17