Husqvarna K1 PACE Notice D'utilisation page 16

Note:
Many cutting blades that can be attached to this
product are made for stationary saws. The rated speed
value of those cutting blades is too low for this product.
WARNING:
blades with thickness exceeding maximum
recommended thickness. Refer to
data on page 38 .
• Cutting blades applicable to this product are
available in two basic models; bonded abrasive
blades and diamond blades.
• Make sure that the cutting blade has the correct
center hole dimension for the installed arbor
bushing.
Abrasive blades
WARNING:
with water. Water or moisture decreases the
strength of the abrasive blade and increases
the risk that the blade breaks.
CAUTION:
is not permitted with the Vac attachment.
Use of abrasive blade causes too much
wear on the Vac attachment.
WARNING:
on correct material.
• Do not use wheels from larger power tools. Wheels
of a larger power tool are not correct for the higher
speed of a smaller tool and may break.
• The cutting material on abrasive blades is bonded
with natural material that have a gravel bonded
agent. Blades that are made up of a fabric or fibre
are stronger. This type of blade does not break if
the blade gets cracks or becomes damaged during
operation.
16
Do not use cutting
Technical
Do not use abrasive blades
Cutting with abrasive blade
Use correct abrasive blade
• The performance of a cutting blade is given by
the dimension of abrasive grain, and the type and
hardness of the bonding agent.
Bonded abrasive cutting blades for different materials
Note:
Make sure that you use the correct cutting
blades for rail cutting.
Blade type Material
Stone Con- Concrete, asphalt, stone masonry,
crete blade cast iron, aluminum, copper, brass,
cables, rubber and plastic.
Steel blade Steel, alloy steel and other hard met-
al.
Rail blade Railway rail.
To examine a bonded abrasive cutting blade
• Make sure that there are no cracks or damages on
the cutting blade.
• Hang the cutting blade on your finger and hit the
cutting blade lightly with a screwdriver. If you do not
hear a clear sound, the cutting blade is damaged.
Diamond blades
WARNING:
very hot when used. A diamond blade that
is too hot gives bad performance, blade
damage and is a safety risk.
xxxx
Diamond blades become
1598 - 006 - 06.09.2023