Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Troubleshooting
Problem
The recipient acknowledges the alarm call, but then the SD1+ dials
the second, third and fourth phone numbers.
Cause
The acknowledgement option is set to
(See page 15 for more information).
Remedy
Please check that the setting is correct.
Problem
The unit does not dial the set phone number.
Cause
The phone number is incorrectly dialled
Remedy
Check the entered phone number (pages 16-18).
Cause 2
The SD1+ is connected to an internal PABX that requires
a "0" prefix and may also require a pause after the "0".
Remedy 2 Make sure the prefix and pause settings are correct.
Cause 3
The unit is connected to an exchange that requires a
special signal to select a line.
Remedy 3 The SD1+ can only operate with commercially available exchanges
(prefix "0").
Problem
The SD1+ was triggered by the alarm control panel but only SD1+
shows in the display.
Cause
This is normal procedure.
Remedy
Only in test mode is the status of the SD1+ displayed (see page 25).
Problem
The recipient cannot acknowledge the alarm call by pressing
Cause
The recipient telephone is not tone-enabled (MFV).
Remedy
Call the recipient and request him/her to press
You should hear a tone. If not, the recipient can purchase a tone pad that
simulates MFV tones. Contact your dealer.
Problem
I press the
display; it always shows
Cause
The SD1+ requires a 4-digit or 6-digit access code to be entered before
you can access the programming mode.
Remedy
Enter a valid passcode.
26
e
key 6 seconds but
PLEASE RECORD
ANY-2
ANY-3
ALL-4
or
or
8
.
8
on the telephone handset.
READY
does not show in the
SD1
or
+
.
Publicité
