Menvier SD1+ Manuel D'utilisation Et De Programmation page 47

All manuals and user guides at all-guides.com
The SD1+ can record an identification message and four alarm
messages for a total of 40 seconds. The identification message is
usually used to convey general information about the location and
alarm system while the remaining four messages are assigned to
the alarm inputs. At the end of the alarm message it is advisable to
refer to the acknowledgment procedure.
• Identification message: "This is George Smith at 10 Example
Street, Exampleville"
• Message A: "Burglary alarm, please press eight to acknowledge
this call."
1. Ensure that the SD1+ is initialised and the display is
READY
showing (see page 8).
e
2. Press . The display shows
0
3. Press for the general identification message.
0ABCD
1 4
to selects the corresponding phone number.
RECORD PHRASE 0
4. The display shows
You should stand about 30cm from the unit when
recording the message.
It is advisable to write down the message text beforehand.
e
5. Press to begin recording.
The display shows the remaining time.
If you are re-recording a phrase, the duration of the new
message must be the same as that of the old message
(e.g. 10 seconds); otherwise, delete the old recording first.
^
6. Press to stop recording.
The unit will also stop recording when the time runs out.
7. Repeat the procedure for phrases A, B, C and D.
^
8. Press to finish.
Recording messages
ENT 1-4 OR 0-C
selects the corresponding message.
????
PHRASE 0
.
This is
George Smith,
10 Example Street,
Exampleville
SD1+
READY
e
ENT 1-4
OR 0-C
0
RECORD
e
REC - 40
REC - 32
^
ENT 1-4
OR 0-C
^
READY
19