Menvier SD1+ Manuel D'utilisation Et De Programmation page 46

All manuals and user guides at all-guides.com
If the SD1+ is connected to the telephone network via an internal
telephone exchange (PABX), a dial out prefix is usually required. In
most cases it is "0" and is dialled before you dial the actual phone
number. Older exchanges require a pause between the "0" and the
phone number. In the example below, a pause of 3 seconds is
required after the "0" prefix.
1. Ensure that the SD1+ is initialised and the display is
READY
showing
e
2. Press . The display shows
1
3. Press for phone number 1.
1 4
to selects the corresponding phone number.
0 ABCD
4. The display now shows the selected phone number and the
programmed digit (
If a phone number has already been programmed, it can be
deleted by pressing the
0
5. Press (i.e. the exchange prefix) and then press
times for the pause. Press
A pause is represented as a comma (,).
6. The SD1+ shows
7. Now enter the actual phone number and press
8. Repeat the procedure for phone numbers 2, 3, and 4.
^
9. Press to finish.
A pause (,) causes the SD1+ to wait 3 seconds before the
rest of the number is dialled. Two (or three) pauses cause
the SD1+ to wait 6 (or 9) seconds.
18
Programming a dialling pause
(see page 8).
ENT 1-4 OR 0-C
selects the corresponding message.
BLANK
= empty).
A
key.
C
to move the cursor to the right.
0
, (i.e. the prefix and a comma) in the display.
.
018112
345678
B
three
e
.
SD1+
????
READY
e
ENT 1-4
OR 0-C
1
TEL NO 1
BLANK
0 B B B C
0,*
2345678*
e
ENT 1-4
OR 0-C
^
READY