Menvier SD1+ Manuel D'utilisation Et De Programmation page 36

All manuals and user guides at all-guides.com
When powering up the speech dialler the first time, a factory reset
is necessary. This involves shorting the factory restart pins with
a screwdriver (see the Installation Instructions). You then see
PLEASE RECORD
is completely blank (deleted). Once the unit is programmed,
SD 1+
shows in the display. To access the programming mode a
????
valid passcode
1234).
1. When the unit is powered up the first time,
PLEASE RECORD
Once programmed, the display shows
2. Enter the default access code
(initialise) the control panel programming mode.
3. Once initialised,
can now be programmed.
^
Press to exit the menu. If the unit is not operated
for one minute,
display.
8
Programming: initialising the SD1+
in the display. This means that the memory
must be entered (factory default:
shows in the display.
1234
READY
shows in the display and the unit
PLEASE RECORD
or
SD1+.
to start
SD1+
shows in the
PLEASE
RECORD
????
READY
^
PLEASE
RECORD
SD1+
????
READY
^
SD1+