Menvier SD1+ Manuel D'utilisation Et De Programmation page 53

All manuals and user guides at all-guides.com
Display messages in normal operation
PLEASE
When the unit is powered up the first time, it must be
initialised. After that the alarm numbers and messages can be
RECORD
programmed.
SD1+ This is the stand-by mode display. It appears once the unit has
been initialised and programmed and during an alarm call.
If this displays even though you have carried out a factory
reset (see Installation Instructions), contact your supplier for
technical support.
ABORTED
This display indicates that the alarm call was aborted by the user
while the unit was attempting to make an alarm call.
Display messages in test mode
The SD1+ has detected a ringing tone.
RINGING
This function is not available in all countries.
The intended recipient's line is busy. The SD1+ again attempts
ENGAGED
to establish a connection.
The recipient telephone terminal is not compatible.
UNOBTAIN
It is a different kind of telephone device (e.g. fax machine).
Check the alarm phone number.
This function is not available in all countries.
Transmission of the alarm was successful and
SENT OK
acknowledged by the recipient.
The alarm call was not answered or not
NO REPLY
acknowledged by the recipient.
25