Ryobi FVH61 Manuel D'utilisation page 7

WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
While the tip is hot, wipe the tip against a damp sponge or
a metallic wool pad to remove debris. Keeping a clean tip is
important to extend the life of the tip. The RYOBI Soldering
Iron Tip Cleaner (A126TC1) will help improve solder melting
and flow during use.
REPLACING SOLDERING TIPS
See Figure 4, page 8.
WARNING:
Always allow the soldering pen tip to cool for a minimum
of 10 minutes before removing the tip. Touching a hot
soldering tip can result in serious personal injury.
WARNING:
This soldering pen is designed to be used only
with the tip models that are specified in this
Operator's manual. Use of other soldering pen tips could
cause serious personal injuries or property damage.
This soldering pen may be used with only the following RYOBI soldering pen tips. Look for these accessories where you
purchased this product or call 1-800-525-2579:
 Combo Pack: Fine Point, Chisel Point, and Beveled Point Soldering Pen Tips..................................................A126FCBT1
 Soldering Iron Tip Cleaner........................................................................................................................................A126TC1
FOLLOWING FRENCH AND SPANISH LANGUAGE SECTIONS
MAINTENANCE
ACCESSORIES
NOTE: ILLUSTRATIONS START ON PAGE 8
7 — English
WARNING:
Read and understand the entire Operator's Manual for
each optional soldering pen tips used on this soldering
pen and follow all warnings and instructions. Failure to
follow all the instructions could result in electric shock,
fire, and/or serious personal injury.
WARNING:
Never install, remove or adjust any soldering pen tips
while the soldering pen is on, or before the tip has not
had sufficient time to cool. Failure to do so can cause
serious personal injury. Never operate without a soldering
pen tip installed.
To install a soldering pen tip:
 Remove the battery pack from the tool.
 Remove the soldering shaft/tip from the tool. Replace
with a new shaft/tip assembly.
 Insert the threaded end of the shaft/tip into the gold
threads on the tool. Tighten until the shaft/tip is securely
in place.
STORAGE
Always remove the battery pack and allow the soldering pen
to cool completely before storing.
WARNING:
Always remove the battery pack before storage to ensure
the product is off. Allow a minimum of 30 minutes of
cool-down time before storage. Storing a soldering pen
with a hot tip can cause serious burns and/or ignite
combustible objects.