Ryobi FVH61 Manuel D'utilisation page 6

To remove:
 Unscrew and remove the battery cap.
 Remove the battery pack from the tool.
For complete charging instructions, see the operator's
manual for your battery pack.
LED LIGHT FUNCTIONS
See Figure 2, page 8.
When a charged battery pack is installed in the tool, the
LED light will indicate the status of the tool when the tool
is powered on.
TOOL STATUS
Heating
Ready for Use
Battery Level <25%
Low Battery
No Tip Present
OPERATING THE SOLDERING PEN
See Figure 3, page 8.
 Install the battery pack.
 Remove the tip cover before turning off the tool.
 Press and hold the on/off button for about 1.5 seconds
to turn the tool on.
NOTE: The LED light will pulse until maximum operating
temperature is reached. Once the set temperature is
reached, the LED light will go solid.
 Always hold the soldering pen as shown. Apply solder
with the tip of the pen.
OPERATION
LED LIGHT SCENARIO
Flashing Green
Solid Green (No Flashes)
Solid Red (No Flashes)
Flashing Red (3 Flashes)
Flashing Green (3 Flashes)
6 — English
 Apply solder only to the tip of the tool at the point where
the tip touches the workpiece.
 Lift the tool away from the workpiece before turning the
pen off.
 After soldering, place the soldering tip cover on the unit
before laying down the tool when not in use.
 Locate the arrow on the soldering tip cover and line the
arrow up with the tool. Insert the tool into the tip cover
and push until you hear a click. The tab inside the tip
cover mates with the tool to turn the unit off.
NOTE: Do not touch the tip while the LED light is solid or
flashing. Allow 10 minutes for the soldering pen to cool
down before touching the tip.
 Clean the soldering tip as described in the Maintenance
section of this manual.
NOTE: Once the LED light turns off, allow 30 minutes for
the soldering pen to cool before storing the tool.
WARNING:
Always place the soldering tip cover on the unit before
laying the tool down. Lay the pen on its side where the
base is located, so the tip does not come in contact with
anything while it is heating or when not in use. Following
this rule will reduce the risk of damage to items, burns,
fire or serious personal injury.
AUTOMATIC SHUT-OFF
After 10 minutes, the unit will turn off. This preserves the tip
and prevents powering an unattended tool. To restore power,
press the button to turn the unit back on.