G-3 Prepare UAS for
Forward-Facing Use
NOTE: Pull the UAS belt out of the rear-facing belt path if
you have used this child restraint rear-facing or remove from
the storage location.
1.
Routing UAS
Insert the UAS hook through the
forward-facing belt path.
The UAS adjuster can be on
either side, but the belt should
not be twisted.
2.
Pull UAS Hook Across to
Opposite Side
Pull the UAS hook across the back
and out the other side as shown.
Do not twist the UAS belt.
49
All manuals and user guides at all-guides.com
Adjuster
G-4 Install Forward-Facing
With UAS
NOTE: Review your vehicle's owner manual for UAS belt use.
Do not use the vehicle lap or lap/shoulder belt
when using the Universal Anchorage System
(UAS).
Check UAS belt before each use. Use only
if the belt can be tightened properly and
securely.
Do not fasten both UAS hooks on the same UAS
anchor bar in the vehicle.
When used in the forward facing position, the
child restraint must be used in the upright
position. Vehicle seat back must be upright.
Failure to follow these warnings can result in
serious injury or death.
1.
Place Child Restraint in Vehicle
Forward-Facing Flush Against
Back Seat
When used in the forward facing
position, the child restraint MUST be
used in the upright position. To
pull recline stand out, see section
C-6.
NOTE: Do not use the level to ground lines on the side of the
child restraint in the forward-facing position.
50
continued on next page.