Publicité
Les langues disponibles
Les langues disponibles
5.
Remove Seat Pad
Pull pad off the top of child
restraint and around headrest.
Remove pad from shell.
Cleaning Pad and Accessories
Machine wash all pieces separately with cold water on a gentle
cycle. Make sure harness covers are closed so fastening strips
are not exposed. Do not use bleach. Tumble dry separately for
10-12 minutes on low heat. Remove immediately.
Harness Straps: Spot clean only. Do not machine or hand
wash.
Do not use this child restraint without the seat
pad. Failure to do this can result in serious
injury.
Installing Pad
Replace seat pad by reversing order for your particular model.
Slip headrest pad on shell. Make sure pad is behind headrest
and backrest.
Attach all of the elastic straps if required.
Install lower harness guides.
Install harness system (see section C-9).
27
All manuals and user guides at all-guides.com
C-9 Install Harness System
1.
Install Buckle Strap
Choose one of the three
slots that is closest to
1
child. From the front of
2
child restraint, push buckle
3
strap's metal retainer
through pad and shell.
Make sure that buckle is facing out.
You
MUST
use the 1st or 2nd buckle strap slots
when rear-facing. Any slot can be used for
forward-facing.
2.
From bottom of child
restraint, pull buckle strap's
metal retainer completely
through pad and shell.
3.
Check Buckle
Pull up on buckle strap to
make sure it is secured.
The buckle must not pull
out.
Failure to place buckle strap's metal retainer
completely through pad and shell can result in
serious injury or death to the child.
28
continued on next page.
Publicité
