Publicité
Les langues disponibles
Les langues disponibles
5.
Pull Vehicle Latch Plate
Across to Opposite Side
2
Reach under pad and pull the
1
vehicle belt across the shell and
out the rear-facing belt path on
opposite side. Buckle vehicle belt.
Vehicle belt MUST be under pad and in front of buckle strap as
shown.
Do not place vehicle belt over child's legs.
NOTE: You must use the 1st or 2nd buckle strap slots
when rear-facing.
6.
Replace Pad Over Corners
Make sure the vehicle belt is not
twisted.
7.
Tighten Vehicle Belt
Push down firmly on the
child restraint and pull on the
vehicle shoulder belt or lap
belt to tighten.
With a switchable retractor,
feed the shoulder belt back
into the retractor while
tightening.
It may be easier to tighten
the belt through the belt path
opening as shown.
45
All manuals and user guides at all-guides.com
Check Vehicle Belt
8.
Tightness
Grasp the child restraint
at the belt path with one
hand. Push and pull the
child restraint from side to
side, forward and back. The
child restraint should not move more than 2.5 cm (1 in)
and the vehicle belt should not loosen.
NOTE: If it moves more than 2.5 cm (1 in.) or if the vehicle
belt loosens, try reinstalling the child restraint or try
another seating location.
Secure Child In Child
9.
Restraint
10.
Recheck Recline Angle
Make sure the child
restraint is properly reclined
according to your child's
weight. Repeat steps 1
through 9 if it is not reclined
properly.
46
Publicité
