Busch+Müller IQ-X E Notice D'utilisation page 13

6.3 Suspended assembly
ATTENTION: If the headlight is to be mounted in a suspended position, please ensure to not simply
1
turn it or place it upside down. Other road users would be dazzled!
!
In order to align the headlight correctly in a suspended position, loosen the plastic ring around the
headlight 1 and turn it by 180°. For this purpose, detach the headlight
bracket 2 first and then slightly spread the circumferential plastic ring and move the ring around the
headlight by 180°.
1
WARNING Make sure that the cable outlets on the headlight
is the only way to ensure that the light pattern of the headight
water penetration in the best possible way.
NOTICE The headlight 1 must be mounted either upright (Busch + Müller bracket
outlet pointing in exactly the same direction) or suspended and rotated by 180° (Busch + Müller bracket
and the cable outlet pointing in exactly the opposite direction). Otherwise, there is a risk that the
2
headlight 1 might adjust all by itself.
For suspended assembly, the reflector 3 must not be mounted „overhead". Please mount the the reflec-
tor 3 elsewhere parallel to the road at a height between 400 and 1,200 mm.
24
1 from the Busch + Müller
1 always point straight down. This
1 is ideally aligned and protected from
2 and the cable
A
C
B
25