Busch+Müller IQ-X E Notice D'utilisation page 11

5. Technical specification
Headlight dimensions: Height: 55 mm | Length: 46 mm | Width: 54 mm | 120 g
Brightness: 150 Lux
Nominal voltage: 5 - 48 V DC
Precondition: at least 7.5 W nominal capacity at the light connection of the drive system
NOTICE Never connect to an AC voltage source (e.g. dynamo).
NOTICE If your e-bike has a dynamo to power the lighting system, you will need a standard dynamo
headlight.
6. Assembly
6.1. General information
!
Make sure your headlight is not covered under any circumstances. Take care that the headlight has
been mounted and aligned as prescribed. For headlights with a separate reflector, make sure that the
make sure that the reflector is aligned perpendicular to the road surface.
3
In Germany, the prescribed mounting height for headlights
400 and 1,200 mm. For details, consult your national Road Traffic Regulations or contact a local bicycle
specialist retailer. Always make sure the headlight is mounted and aligned in a way to ensure that
oncoming traffic is not blinded.
20
1 and reflectors 3 ranges between about
WARNING To avoid falls, accidents and severe injuries, always use the enclosed Busch +
Müller assembly bracket. If unsuitable or improperly positioned brackets are used, the headlight
may probably come loose, slide down and, in the worst case, get caught in the wheel spokes.
NOTICE Never mount brackets on forks or seat stays!
NOTICE Never mount brackets on conical components!
Make sure to tighten all screws in a way to ensure the headlight
This is especially important when cycling on uneven terrain.
1 cannot move all by itself.
21