Télécharger Imprimer la page

Ribimex RIBITECH PRSCE180/1400 Manuel D'instructions Et D'utilisation page 28

Publicité

Les langues disponibles

Les langues disponibles

8. Place the accessory on the material. Do not make any sudden movements.
Guide the tool on the workpiece to be cut by applying a constant pressure.
Do not exert excessive pressure on the machine, let the machine do the work.
Working by applying successive pressures may cause random cutting and likely to shorten the life of the
accessory and tool.
Apply less pressure when the tool starts to vibrate heavily.
9. Once the work is finished, stop the tool by releasing the switch.
Note: Do not touch the cutting blade and do not put the machine down before it has come to a complete stop.
5.3- Use
a) Making a cut
With a pencil, mark the line of cut on the work piece.
Adjust the depth of cut and bevel angle as required.
When making 90° cross or rip cuts, align your line of cut with the outer blade guide notch on the base of the
saw.
When making 45° bevel cuts, align your line of cut with the inner blade guide notch on the base of the saw.
Rest the front edge of the base on the workpiece. Make sure the power cord is out of the way of saw the
blade and not in the line of cut.
Start the motor by depressing the lock-off button and squeezing the trigger switch.
NOTE: Always let the blade reach full speed before you begin to cut into the workpiece.
Slowly push the saw forward using both hands. Apply downward pressure to keep the saw steady and only
enough forward pressure to keep the blade cutting.
When making a cut always use steady, even pressure. Forcing the saw causes rough cuts and could shorten
the life of the saw or cause kickback. Allow the blade and the saw to do the work.
After completing your cut, release the trigger switch and allow the blade to come to a complete stop. Do not
remove the saw from the workpiece while the blade is moving.
NOTE: Since blade thickness varies, always make a trial cut in scrap material along the guideline to
determine how much, if any, the guideline must be offset to get an accurate cut.
b) Making a plunge cut
WARNING: To avoid loss of control, always use extreme caution when making plunge cuts.
Adjust the depth of cut as required.
Adjust the bevel setting to 0°.
Raise the lower blade guard lever (with lever 18) to expose the saw blade and firmly rest the front of the
base flat against the workpiece with the main handle raised so the blade does not touch the workpiece.
With the blade just clearing the workpiece, start the motor by depressing the lock-off button and squeezing
the trigger switch.
Always let the blade reach full speed before you begin to cut into the workpiece.
Slowly lower the saw into the workpiece, using the front of the base resting on the workpiece as a hinge
point.
WARNING: As soon as the blade starts cutting the material, release the lower blade guard lever.
Once the base plate is flat against the workpiece, proceed cutting in a forward direction to the end of the cut.
After completing your cut, release the trigger switch and allow the blade to come to a complete stop. Do not
remove the saw from the workpiece while the blade is moving.
If the corners of your pocket cut are not completely cut through, use a jigsaw or hand saw to finish the
corners.
WARNING: Always cut in a forward direction when making a pocket cut. Cutting in the reverse direction
could cause the saw to climb up on the workpiece and back toward you, possibly causing serious injury.
WARNING: Never tie the lower blade guard in a raised position. Leaving the blade exposed could lead to
serious injury.

Publicité

loading

Ce manuel est également adapté pour:

Ribitech 601069