Makita DTM52 Manuel D'instruction page 9

3. Return the lock lever to its original position.
Always make sure that the application tool is securely held in place.
1
► 1. Lock lever
To remove the application tool, follow the installation
procedures in reverse.
CAUTION:
When removing the application
tool, do not touch the application tool or the work-
piece immediately after operation; they may be
extremely hot and could burn your skin.
Using sanding application tool
When using sanding application tool, mount the application tool
on the sanding pad so that it matches the sanding pad direction.
The sanding pad has a hook and loop type fitting system
which allows easy and rapid fitting of a sanding paper.
As sanding papers have holes for dust extraction,
mount a sanding paper so that the holes in a sanding
paper match those in the sanding pad.
1
► 1. Sanding paper
To remove a sanding paper, raise its end and peel it off.
OPERATION
WARNING:
Before starting the tool and during opera-
tion, keep your hand and face away from the application tool.
CAUTION:
Do not apply excessive load to the
tool which may cause a motor lock and stop the tool.
CAUTION:
Do not operate the tool with press-
ing the battery cartridge against the tool.
NOTICE:
If you operate the tool with forcing or
excessive pressure, the overload alert may work and
then the amplitude of vibration increase.
In this case, once isolate the application tool from
the workpiece, then the speed of the oscillation goes
back. Continue operation with an appropriate load.
Cutting, sawing and scraping
NOTICE:
Do not move on the tool forcibly in the
direction (e.g. towards either side) of the appli-
cation tool with no cutting edge. It may damage
the tool.
NOTICE:
Operate the tool with appropriate load.
Forcing or excessive pressure on the tool may reduce
efficiency.
Especially when operating the tool with a long blade
(e.g. plunge cut saw blade), applying too much pres-
sure that the blade bends may not only reduce effi-
ciency but also activate the protection system.
Put the application tool on the workpiece.
And then move the tool forward so that the application
tool movement does not slow down.
NOTE: Before cutting operation, it is recommended to
preset the orbital stroke rate 4 - 6.
NOTE: An adequate movement speed of the tool
makes saw dust ejected smoothly. It helps efficient
operation.
NOTE: The round saw is recommended for cutting
long straight line.
Sanding
NOTICE:
Do not reuse a sanding paper used for
sanding metal to sand wood.
NOTICE:
Do not use a worn sanding paper or
sanding paper without grit.
9 ENGLISH