MSW Motor Technics MSW-PLT-6 Manuel D'utilisation page 52

•
•
3.3.3 Starting and working
IMPORTANT: before putting it into operation, make sure that the
hearth (12) is filled with pellets and that the ash container (13 or 15
depending on the model) is correctly positioned (see the pictures
below):
Before ignition, the remains of unburned pellets must be removed
from the hearth.
a) Switching on/off
To start the stove, put the power switch (14 or 16) in the "I"
position and press the on/off button (a). The device will start and
enter the automatic ignition mode, and the information on the
display will look like this:
Similarly, use the same button (a) to turn off the stove, and the
display will be as follows:
Set the red power switch (14) to the ON ("I") position - it
should light up, which means that the stove has power and
started working.
After start-up, the stove system will go into the self-
diagnosis procedure and if successful, the device is ready
for operation.