How To Manage: Error Codes; Service Data - AEG BSK788380M Notice D'utilisation

Problems with Wi-Fi signal
Possible cause
The wireless signal is disrupted by a micro‐
wave appliance placed near the oven.

12.2 How to manage: Error codes

When the software error occurs, the display shows error message.
In this section, you will find the list of the problems that you can handle on your own.
Code and description
F111 - Food sensor is not correctly inserted in‐
to the socket.
F240, F439 - the touch fields on the display do
not work properly.
F601 - there is a problem with Wi-Fi signal.
F604 - the first connection to Wi-Fi failed.
F908 - the oven system cannot connect with
the control panel.
When one of these error messages continues to appear on the display, it means a faulty
subsystem may have been disabled. In such a case contact your dealer or an Authorized
Service Centre. If one of these errors occurs, the rest of the oven functions will continue to work
as usually.
Code and description
F602, F603 - Wi-Fi is not available.

12.3 Service data

If you cannot find a solution to the problem yourself, contact your dealer or an Authorised
Service Centre.
TROUBLESHOOTING
Remedy
Turn off the microwave appliance.
Remedy
Fully plug Food sensor into the socket.
Clean the surface of the display. Make sure
there is no dirt on the touch fields.
Check your network connection. Refer to "Be‐
fore first use" chapter, Wireless connection.
Turn the oven off and on and try again. Refer to
"Before first use" chapter, Wireless connection.
Turn the oven off and on.
Remedy
Turn the oven off and on.
41/252