Publicité
Les langues disponibles
Les langues disponibles
2610051955.qxp_ROS10 ROS20VS 8/16/18 1:58 PM Page 9
Your tool is equipped with an integrated
backing pad damper ring. This damper
reduces the no-load speed, which helps
prevent swirl marks on the workpiece surface
and provides uniform finishing.
NOTE: If you notice steadily increasing no-
load speed, this indicates that the damper ring
is worn and needs to be replaced.
To replace damper ring, remove backing pad
as described in "Backing Pad Installation" and
remove worn damper ring by pulling firmly out
of locating groove. Loosen the two screws on
shroud just enough so you can separate
shroud approximately 1/4 inch. Align locating
bumps on damper ring with cut outs in shroud
and depress ring with thumbs until shroud
seats into groove completely around ring, then
tighten screws (Fig. 5).
Re-attach backing pad as described in
"Backing Pad Installation"
MICROFILTER DUST CANISTER
The integral dust extraction system collects
sanding dust in canister supplied with your
sander. For maximum efficiency, the dust
canister should be emptied frequently during
operation.
empty it frequently after completion of
sanding and before storing the sander. Be
extremely careful of dust disposal, materials in
fine particle form may be explosive. Do not
throw sanding dust on an open fire.
FIG. 6
1
Quality Products Online at:
BACKING PAD DAMPER
Your tool is equipped
with a dust canister;
MICROFILTER
2
DUST CANISTER
GlobalTestSupply
www.
IMPORTANT: Ring should not have bends or
ripples when correctly seated.
FIG. 5
DAMPER
RING
SHROUD
Dust Collection
Combustion from mixture of varnishes,
lacquers, polyurethane, oil or water with dust
particles can occur if there is a static
discharge, spark introduced in the box, or
excessive heat.
REMOVING AND INSTALLING
To remove dust canister: Twist the canister
left or right and simply pull away from the tool
(Fig. 6).
To install dust canister: align dust port with
hole in canister and push canister onto tool
until it locks into place (Fig. 7).
FIG. 7
MICROFILTER
DUST CANISTER
-9-
BEARING
AFTER
FLANGE
COVER
REMOVED
LOCATING BUMPS
ON UNDERSIDE OF
DAMPER RING
DUST CANISTER
DUST PORT
.com
sales@GlobalTestSupply
BACKING
PAD
Publicité
