Husqvarna 359 Manuel D'utilisation page 41

Recommended cutting equipment for Canada
The following is a list of recommended cutting equipment for Class 1A and 1B Chainsaws. The combinations of
powerhead, bar and chain meet all requirements outlined in the CSA Z62.1-95 Chainsaws and Z62.3-96 Chainsaw
Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent
or less kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which
are available at your dealer.
Bar and chain combinations
Length, inch Pitch, inch
13 0,325
15 0,325
16 0,325
18 0,325
20 0,325
13 0,325
15 0,325
16 0,325
18 0,325
20 0,325
15 3/8"
16 3/8"
18 3/8"
20 3/8"
24 3/8"
Note: For the saw chains above (if available) you are free to choose between 0,050" or 0,058" gauge drive links for the
corresponding bar, see the table below
Technical data
Bar
Gauge, inch Max. nose radius
1,5 10T
1,5 10T
1,5 10T
1,5 10T
1,5 12T
1,3 10T
1,3 10T
1,3 10T
1,3 10T
1,3 10T
1,5 11T
1,5 11T
1,5 11T
1,5 11T
1,5 11T
Chain
Type
Husqvarna H25
Husqvarna H30
Husqvarna H42
Drive link count
56
64
66
72
78
56
64
66
72
78
56
60
68
72
84
English – 41