VINCI EXPRESS COLD BREW Instructions page 11

CARE AND CLEANING OF THE CONTROL LID
To ensure optimal performance from your Vinci Express Cold Brew, follow these Care and
Cleaning instructions after every brew cycle.
CONTROL LID
DO NOT SUBMERGE
IN WATER
2/3
WATER FILL
DIRTY CLEAN
19
1. NEVER submerge the Control Lid in water or
any other liquid. NEVER place Control Lid in a
stream of water or any other liquid. Doing so will
damage the Express Cold Brew, which could lead
to personal injury and will void your warranty.
MAX FILL
2. Fill the Cleaning Cup about 2/3 full with clean
fresh water.
3. Inspect the bottom of the Water Pickup Tube to
see if any brewing material has collected on the
filter. If so, gently rinse ONLY the bottom of the
Water Pickup Tube to clear any debris.
4. Place the Control Lid into the Cleaning Cup.
CARE AND CLEANING OF THE CONTROL LID
5. Rotate the Control Knob to CLEAN.
6. Press the Brew button to start the cleaning
process. The fresh water from the cleaning cup will
run through the pump, flushing out any remnants
from the prior brew cycle.
7. After the Clean cycle is complete, raise the
Control Lid until the Water Pickup Tube is no
longer touching the water in the Cleaning Cup.
Press the Brew button again so air runs through the
pump system and evacuate any remaining water.
8. Empty any remaining water in the Cleaning Cup
and rinse it clean to be ready for the next use.
20