Lamborghini Caloreclima ECO 3 R Notice D'installation Et D'entretien page 24

FAULT FINDING
Motor does not work
Motor works but there is nofla-
me formation and with
Burner starts and flame forms,
Flame is irregular and small
Flame is smokey
WARNING:In the event of replacement or assem-
bly/disassembly of the fan, make sure that the latter
does not touch the motor platform as illustrated in
the inclosed diagram.
GB
24
PROBLEM PROBABLE CAUSE
No power supply
a) electrodes are not dischar-
ged
b) nozzle is dented
a) photoresistance is dirty
a) nozzle is pulverizing badly
b) pump pressure is too low
a) nozzle is pulverizing badly
SOLUTION
a) check fuses
b) check thermostats
a) check correct position of
tipsand clean them
b) clean or replace nozzle
c) check Light Oil level in tank
and that there are no shutters
closed along the Light Oil line.
a) clean the photoresistance
a) clean or replace nozzle
b) check and increase pressure
c) extract water from tank and
clean the filter
a) clean or replace nozzle
b) check atmospheric air flap
opens normally. Check that fan