Chamberlain LiftMaster Professional 379E Mode D'emploi page 3

STEP 4 PROGRAM TO OPENER
NOTE: The unit must have an enrolled user before it can be
programmed to the opener. Due to the 30 second time interval,
a second person may be needed to press the "learn" button.
1. Press and release the "learn" button on the motor unit
of the garage door opener. See illustration above.
2. Open cover and wait for Ready LED
to light.
3. Within 30 seconds of pressing the
"learn" button, slowly and firmly swipe
enrolled finger.
NOTE: The Retry LED will light if another
swipe is needed.
4. After a passed swipe the Pass LED
will light followed by a lit Send LED.
The opener lights will flash.
Programming is complete.
5. If the opener lights don't flash, press
and release the Resend button at 1
second intervals for up to 5 seconds
until the opener lights flash or the door
moves. Programming is complete.
NOTE: If unit will not program to opener repeat the steps
above or refer to Troubleshooting.
All manuals and user guides at all-guides.com
1 2 3
–
O
180 s 60 s
120 s
1
2
ENROLL
SEND ENROLL
PASS FAIL
READY RETRY
3
4
ENROLL
SEND ENROLL
PASS FAIL
READY RETRY
5
STEP 5 OPERATION
1. Open cover and wait until Ready LED
is lit.
2. Swipe finger slowly and firmly down
the sensor strip.
3. The Pass LED will flash and garage
door will either open or close.
NOTE: If cover is already open, press either the Resend or the
Enroll button to turn unit on. The Fail or Retry LED will light if
another swipe is needed. If this occurs, swipe slowly and with
more pressure. It may require multiple swipes to get a passed
swipe.
While the door is traveling the Send LED will be lit. During this
time the only way to reverse or stop the door is to press the
Resend button.
1
ENROLL
SEND ENROLL
PASS FAIL
READY RETRY
2
3
ENROLL
SEND ENROLL
PASS FAIL
READY RETRY