Black & Decker EPC126 Mode D'emploi page 7

♦ The intended use is described in this
instruction manual. The use of any accessory
or attachment or performance of any operation
with this tool other than those recommended
in this instruction manual may present a risk of
personal injury and/or damage to property.
Vibration
The declared vibration emission values stated in
the technical data and the declaration of conformity
have been measured in accordance with
a standard test method provided by EN 60745 and
may be used for comparing one tool with another.
The declared vibration emission value may also be
used in a preliminary assessment of exposure.
Warning! The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which
the tool is used. The vibration level may increase
above the level stated.
When assessing vibration exposure to determine
safety measures required by 2002/44/EC to
protect persons regularly using power tools in
employment, an estimation of vibration exposure
should consider, the actual conditions of use and
the way the tool is used, including taking account
of all parts of the operating cycle such as the times
when the tool is switched off and when it is running
idle in addition to the trigger time.
Labels on tool
The following pictograms are shown on the tool:
Warning! To reduce the risk of injury, the
user must read the instruction manual.
Additional safety instructions for batteries
and chargers
Batteries
♦ Never attempt to open for any reason.
♦ Do not expose the battery to water.
♦ Do not store in locations where the
temperature may exceed 40 °C.
♦ Charge only at ambient temperatures between
10 °C and 40 °C.
♦ Charge only using the charger provided with
the tool.
♦ When disposing of batteries, follow the
instructions given in the section "Protecting the
environment".
Do not attempt to charge damaged
batteries.
All manuals and user guides at all-guides.com
Chargers
♦
♦
♦
♦
♦
♦
Electrical safety
♦
Features
This tool includes some or all of the following
features.
1. Variable speed switch
2. Forward/reverse slider
3. Mode selector / torque adjustment collar
4. Chuck
5. Speed selector
6. Bit holder
7. Battery
Fig. A
8. Charger plug
9. Charger
10. Charger receptacle
Assembly
Warning! Before assembly, remove the battery
from the tool.
ENGLISH
Use your Black & Decker charger only to
charge the battery in the tool with which it was
supplied. Other batteries could burst, causing
personal injury and damage.
Never attempt to charge non-rechargeable
batteries.
Have defective cords replaced immediately.
Do not expose the charger to water.
Do not open the charger.
Do not probe the charger.
The charger is intended for indoor use
only.
Read the instruction manual before use.
The charger automatically shuts off if the
ambient temperature becomes too high.
The thermal cut out operates only once
and then requires complete replacement.
Your charger is double insulated; therefore
no earth wire is required. Always check
that the mains voltage corresponds to the
voltage on the rating plate. Never attempt
to replace the charger unit with a regular
mains plug.
If the supply cord is damaged, it must be
replaced by the manufacturer or an authorised
Black & Decker Service Centre in order to
avoid a hazard.
7