Publicité
Les langues disponibles
Les langues disponibles
STOP ALARM ALERT & SNOOZE
1. Press [ SNOOZE / LIGHT ] key to stop the current alarm and enter snooze. Alarm icon will be flashing
continuously. The alarm will sound again in 5 minutes. Snooze can be operated continuously in 24 hours.
2. When the alarm is sounding, it will stop automatically without pressing any key in 2 minutes. Also you can
press and hold the [ SNOOZE / LIGHT ] key for 2 seconds or press [ ALARM ] key to stop the current
alarm. And the alarm will automatically sound again at the alarm time next day.
WEATHER FORECAST
The device contains sensitive pressure sensor built-in with sophisticated and proven software that predicts
weather for the next 12 ~ 24 hours within a 30 to 50km (19-31 miles) radius.
Note:
1. The accuracy of a general pressure-based weather forecast is about 70% to 75%.
2. The weather forecast is meant for the next 12 hours, it may not necessarily reflect the current situation.
3. The "Snowy" weather forecast is not based on the atmospheric pressure, but based on the outdoor
temperature. When the outdoor temperature is below -3°C (26°F), the "Snowy" weather indicator will be
displayed on the LCD.
BAROMETRIC / ATMOSPHERIC PRESSURE
Atmospheric Pressure is the pressure at any location of the Earth caused by the weight of the column of
air above it. One atmospheric pressure refers to the average pressure and gradually decreases as altitude
increases.
Meteorologists use barometers to measure atmospheric pressure. Since variation in atmospheric pressure
greatly affected by weather, it is possible to forecast the weather by measuring the changes in pressure.
To select the display mode:
Press and hold [ BARO ] button for 2 seconds to toggle between:
• ABSOLUTE
the absolute atmospheric pressure of your location
• RELATIVE
the relative atmospheric pressure based on the sea level
To set relative atmospheric pressure value:
1. Get the atmospheric pressure data of the sea level (it is also the relative atmospheric pressure data of your
home area) through the local weather service, internet and other channels.
2. Press and hold [ BARO ] button for 2 seconds until "ABSOLUTE" or "RELATIVE" icon flashes.
3. Press [ UP ]/[ DOWN ] button to switch to "RELATIVE" mode.
4. Press [ BARO ] button once again until the "RELATIVE" atmospheric pressure digit flashes.
5. Press [ UP ]/[ DOWN ] button to change its value.
6. Press [ BARO ] button to save and exit the setting mode.
Note:
1. The default relative atmospheric pressure value is 1013 hPa (29.91 inHg), which refers to the average
atmospheric pressure.
2. When you change the relative atmospheric pressure value, the weather indicators will change along with it.
3. The built-in barometer can notice the environmental absolute atmospheric pressure changes. Based on the
data collected, it can predict the weather conditions in the forthcoming 12 hours. Therefore, the weather
indicators will change according to the detected absolute atmospheric pressure after you operate the clock
for 1 hour.
4. The relative atmospheric pressure is based on the sea level, but it will change with the absolute
atmospheric pressure changes after operating the clock for 1 hour.
3
Publicité
