STIL STATION METEO PROFESSIONNELLE AVEC CAPTEUR SANS FIL 5-EN-1 Manuel De L'utilisateur page 27

INSTALLATION
Install WIRELESS 5-IN-1 WEATHER SENSOR
Your wireless 5-IN-1 sensor measures wind-speed, wind-direction, rainfall, temperature and humidity for you.
It's assembled and calibrated for your easy installation.
INSTALL BATTERIES
Unscrew the battery door at bottom of unit and insert the batteries
according to the +/- polarity indicated.Screw the battery door
compartment on tightly.
Note:
- Ensure the water tight O-ring is properly aligned in
place to ensure water resistant.
- The red LED will begin flashing every 12 seconds.
ASSEMBLY THE STAND AND POLE
Step 1
Insert the top side of the pole to the square hole of the
weather sensor.
Note:
Ensure the pole and sensor's indicator align.
Step 2
Place the nut in the hexagon hole on the sensor,
then insert the screw in other side and tighten it
by the screw driver.
Step 3
Insert the other side of the pole to the square
hole of the plastic stand.
Note:
Ensure the pole and stand's indicator align.
Step 4
Place the nut in the hexagon hole of the stand,
then insert the screw in other side and then
tighten it by the screw driver.
2