Rev-A-Shelf 5SOWC-8-1 Instructions D'installation page 2

STEP 1
Center the wire frame on the
door, mark and pre-drill the
hole locations. The door mount
bar may be required for proper
installation on a panel door.
(See Figure 1).
Note: Be careful not to drill
through your door and ensure
not to mount too high on the
door as it will hit the face
frame.
5
#2
64
STEP 2
Use the provided (4) #6
Phillips head screw caps and
#6 x 5/8" Phillips flat head
sheet metal screws to secure
the wire frame to the cabinet
door (See Figure 2A).
Note: Use (4) M4 x 8MM flat
head Phillips screws should
you need to install the frame
on the door mount bar then
to the door with (2) #6 x
5/8" flat head Phillips Sheet
Metal screws (See Figures
2B and 2C).
STEP 3
Insert waste container with
lid into the wire holder and
product is ready for use (See
Figure 3).
2
Without Door Mount Bar
8-1/2"
(216mm)
x x
x x
1-3/4"
(44mm)
Mark screw locations
FIG. 2A
FIG. 2C
Customer Service: 800-626-1126 | rev-a-shelf.com
FIG. 1
With Door Mount Bar
13"
(330mm)
Mark screw locations
FIG. 2B
FIG. 3