Rev-A-Shelf 548-10 Manuel D'installation

548-10 PULL OUT WIRE BASKET TEMPLATE
TOOLS REQUIRED:
TOOLS REQUIRED:
Template
Basket
Frame or Frameless Non Door Mount Installation
1)
Place template on desired cabinet wall and align bottom and side
(Note: fold or cut if needed). Tape in place. (Note: if placing on door
side make sure slides will not interfere with hinges.)
2)
Using a screw tip or awl, mark all (8) holes.
4)
Install slides to brackets using (4) #6 x 1/2" screws into small holes
of bracket. Open slide slightly until large hole is in line with front hole
location (#4 hole) to install front screw. Open slide completely to install
the back screw.
6)
Place basket keyholes over screws and lower basket until resting
on screws.
All manuals and user guides at all-guides.com
548-10 Pull-Out Wire Baskets
Template Instructions
ESTIMATED ASSEMBLY
TIME:
ESTIMATED ASSEMBLY
TIME:
15 MIN
15 MIN
PARTS LIST:
Plastic Brackets (4)
Slides (2)
#6 x 1/2" Screw (4)
#8 x 5/8" Screw (8)
3)
Remove template and install (4) plastic brackets at marked holes
with supplied (8) #8 x 5/8" screws. (Note: small hole on top of bracket
points toward cabinet opening.)
5) Loosely install (4) M4 x 5mm Phillips round washer head screws to
slides.
7) Tighten (4) M4 x 5mm screws and push basket into cabinet.
8)
Install (2) plastic clips.
12400 Earl Jones Way
Louisville, KY 40299
rev-a-shelf.com
Customer Service: 800-626-1126
CARE AND MAINTENANCE:
CARE AND MAINTENANCE:
CLEAN WITH A DAMP CLOTH
CLEAN WITH A DAMP CLOTH AND
AND WIPE PARTS DRY
WIPE PARTS DRY
M4 x 5mm Screw (4)
T-548-10-0417
T-548-10-TRI-0913