Rev-A-Shelf 5190 Serie Guide D'installation Rapide

TOOLS REQUIRED:
Place a flat head screw driver between the metal clip
and plastic hub. Gently pry to relieve pressure by
popping the clip out, taking care to keep it intact.
Fig 1 Plastic Hub
1) Pre-drill mounting holes in the locations marked on this template using a 3/32" drill bit. Be sure the template is centered left to right.
The front edge of the template should be aligned with the back of the door.
2) Use the #8 x 3/4" Phillips head screws provided to secure the unit to the floor. The slide system can be separated if necessary to aid in installation, but removal is not required (See Fig 1 and Fig 2).
3) Ensure that the door mounting brackets allow the mounting screws to engage a part of the door that is at least 3/4" thick (On a 5-panel door, this would be the outer side pieces, or styles). Inset doors
would move the brackets toward the center of the unit while full overlay doors would require the brackets to move outward (See Fig 3). Use the double sided tape provided to temporarily attach the door to
the mounting brackets.
4) Carefully open the unit, being sure not to disengage the double sided tape. Once the unit is open, use the #6 x 1/2" flat head screws to permanently attach the door to the unit. All (8) screws must be used
for proper function. Space screws at opposing corners as much as possible.
Door Adjustment
Vertical mounting slots in the bracket that attach directly to the door can be used for vertical adjustment (See Fig 4).
Horizontal adjustment is achieved by loosening all (4) of the 3/8" nuts that connect to the (2) brackets and moving the door left to right as needed (See Fig 4).
For door tilt adjustment, loosen the (4) #3 Phillips head screws below the skirt and adjust as needed (See Fig 5). The rear screws are slotted to allow the door to pivot at the front of the bracket. Keeping the
front screws "snug" will aid in adjustment.
Front edge of paper
to back of door.
5190 Series Cloth Hamper
Installation Template
ESTIMATED ASSEMBLY TIME:
20 MIN
Fig 2
Press release lever behind side skirt on each side
by sliding up or down depending on which side.
Unit will separate with both levers disengaged.
For horizontal adjustment
loosen (4) 3/8" nuts and
move to desired position.
Fig 4
Many of our products feature installation videos. Visit Rev-A-Shelf.com for more details.
CARE AND MAINTENANCE:
CLEAN WITH A DAMP CLOTH
AND WIPE PARTS DRY
Door thickness must be at least 3/4" where
screws attach.
Mounting screws must engage 3/4"
thick material minimum.
Adjust bracket left to right before
attaching door with double-sided tape.
Use vertical slots for
vertical door adjustment.
Front of unit
Door tilt adjustment screws
Center of cabinet
12400 Earl Jones Way
Louisville, KY 40299
rev-a-shelf.com
Customer Service: 800-626-1126
PARTS LIST:
PULLOUT CHASSIS
HAMPER CONTAINER CHASSIS
HAMPER CONTAINER(S)
(8) #6 X 1/2" FLAT HEAD SCREWS
(5) #8 X 3/4" PAN HEAD SCREWS
DOUBLE SIDED TAPE
(4) Recommended Screw and Pilot
Hole Locations
Fig 3
Fig 5
T-5190-0119-TRI