KitchenAid KUDV25SH Guide D'utilisation Et D'entretien page 16

3. Repeatedly press
until you see the desired hours of delay in the display.
When the delay reaches 9 hours, the delay turns off.
Press DELAY HOURS again to select a new number of
delay hours.
4. Press START.
NOTE: To cancel the delay, press DELAY HOURS until no
delay hours show in the display.
IMPORTANT:
Operate your dishwasher only when you are at home.
If your home is equipped with a water softener, do not
start the dishwasher during the regeneration of the
softener.
Control Panel Light
Rinse Aid Empty
Fill the Rinse Aid dispenser when RINSE AID EMPTY is lit.
A rinse aid prevents water from forming droplets that can
dry as spots or streaks.
If the Rinse Aid dispenser is empty, the light glows when
you select a cycle or while a cycle is running.
Electronic Display
Follow the progress of your dishwasher cycles on the
electronic display. The cycle time is displayed when you
select a wash cycle. The minutes on the display count
down to indicate the time left in a cycle.
NOTE: The sensor may automatically adjust the cycle.
When this happens, you may see the electronic display
pause or skip numbers as it counts down.
16
Child lock
CHILD LOCK glows when all buttons are disabled.
See "Option Selections" for more information.
Water heating
HEATING glows, and the cycle count down pauses,
whenever water is heated during a cycle.
Wash or rinse action continues as the water heats.
Sensing
Your dishwasher senses the soil level on the dishes. Soil
level determines the length of some cycles, the amount of
heat added to a wash or rinse, and the cycle needed for
the load.
SENSING glows during the soil sensing parts of the cycle.
Wash action continues while sensing occurs.
Clean
CLEAN glows when a cycle is finished.
The light turns off when you open the door.
Sanitized
If you select the Sani Rinse option, SANITIZED glows
when the Sani Rinse cycle is finished. The light turns off
when you open the door.
If your dishwasher did not properly sanitize your dishes,
the light flashes at the end of the cycle. This can happen if
the cycle is interrupted.