KitchenAid KUDV25SH Guide D'utilisation Et D'entretien page 14

Canceling a Cycle
Anytime during a cycle, press
The dishwasher pauses for about 5 seconds. Then the
display shows
Your dishwasher starts a 2 minute drain (if needed). Let
the dishwasher drain completely. The light turns off
after 2 minutes.
NOTE: If your dishwasher does not need draining, the light
turns off. Select a new cycle and options.
To stop the drain
You can press Cancel again to stop the drain immediately.
Remember to drain the dishwasher before starting a new
cycle.
NOTE: A small amount of water remains in the dishwasher.
This is normal.
To clear the indicators
Press Cancel before starting the dishwasher to clear all
options and cycles.
14
Changing a Cycle or Setting
During the first 2 minutes of a cycle
1. Press a new cycle and/or options.
2. Check the detergent dispensers. They must be filled
properly for the new cycle.
After the first 2 minutes of a cycle
1. Press
The dishwasher pauses for about 5 seconds. Then
the display shows
Your dishwasher starts a 2 minute drain (if needed).
Let the dishwasher drain completely. The light turns
off after 2 minutes.
NOTE: If your dishwasher does not need draining, the
light turns off. Select a new cycle and options.
2. Check the detergent dispensers. They must be filled
properly for the new cycle.
3. Close the door.
4. Press a new cycle and/or options.
5. Press START.
Adding Items During a Cycle
You can add an item anytime before the main wash starts.
Open the door and check the detergent dispenser. If the
main wash section is still closed, you can add items.
To add items
1. Lift up the door latch to stop the cycle. Wait for the
spraying action to stop before opening the door.
2. Open the door. If the main wash detergent dispenser is
still closed, add the item.
3. Close the door firmly until it latches. The dishwasher
resumes the cycle after about a 5 second pause.