Milwaukee WCE 65 Instructions D'utilisation page 3

Introduction
Technical Data
Safety advice
ENGLISH
All manuals and user guides at all-guides.com
You demand the best and buy quality - quality provided by Milwaukee. We have built
for you a reliable and lasting tool. Working effectively and without endangering your
health is only possible if this instruction for use is read carefully before first using the
tool. We want to satisfy our customers and would like you to buy again Electric
Power Tools from Milwaukee.
Type
Nominal power (W)
No-load speed (min
Grinding disk diameter (mm)
Concrete (Recommendation)
Brick and tile
Cutting depth (mm)
Concrete
Brick and tile
Cutting width (mm)
with standard set of distance plates
with special set of distance plates
Weight (kg)
Smooth start
No-load speed limiter
Overload protection
Infinitely variable cutting width adjustment
Parallel guide
Please pay attention to the safety instructions in the attached leaflet!
Do not pierce the motor housing as this could damage the double insulation (use
adhesives).
Always pull the plug from the mains before making any settings or carrying out main-
tenance.
Only plug-in when machine is switched off.
Keep mains lead clear from working range of the machine. Always lead the cable
away behind you.
Before use check machine, cable, and plug for any damages or material fatigue. Re-
pairs should only be carried out by authorised service agents.
After switching off, the machine will not be idle immediately. (After-running of the
work spindle.) Allow the machine to come to a stop before putting down.
Never reach into the danger area of the machine when it is running.
Always wear safety goggles and ear protectors when working with this machine. It
is further recommended to wear safety gloves, apron, as well as sturdy non-slipping
shoes.
Always keep a safe footing and hold machine with both hands.
Always use the protective shields on the machine.
Always use the additional handle.
Only use the machine with a suitable dust-remover!
Immediately switch off the machine in case of considerable vibrations or if other mal-
functions occur. Check the machine in order to find out the cause.
Only use and store diamond cutting discs according to the manufacturer's instruc-
tions.
Only use sharpened and flawless diamond cutting discs. Immediately exchange
bent or cracked diamond cutting discs. Carry out a test run without load for at least
30 seconds.
Only use tools whose permitted speed is at least as high as the highest no-load
speed of the machine.
3
-1
)
(110 V) WCE 65 WCE 65
2100
6600
200
230
10-55
10-65
17-56
8-16
8.4
•
•
•
•
•
2300
6600
200
230
10-55
10-65
17-56
8-16
8.4
•
•
•
•
•
WCE 65