Milwaukee WCE 65 Instructions D'utilisation page 8

Setting the
cutting width
Spanntec
Set of distance
plates (special
accessory)
Setting the
cutting depth
ENGLISH
All manuals and user guides at all-guides.com
Loosen the Allen screw of the Spanntec-nut
with the T-key (to stop).
Move the outer diamond cutting disc to the
required cutting width.
To lock it in the required position fasten the
Allen screw tightly.
1. Loosen the screw and open and remove the
protective cover.
2. Lock the work spindle by depressing the
spindle lock. Open the round nut of the upper
cutting disc with aid of a pin-type face span-
ner and remove it. Remove the upper cutting
disc.
3. Loosen the Allen screw with the T-key and
remove the Spanntec-nut.
4. Fit the diamond cutting disc to the collar of
the reduction ring and push it together with
the distance plates over the Spanntec-spin-
dle. The collar of the reduction ring must face
outside.
5. Screw down the Spanntec nut on the Span-
ntec-spindle and the round nut on the Span-
ntec-nut.
6. Fasten the Spanntec-nut with aid of the spanner (to steady depress the spindle
lock).
The number of the distance plates between the diamond cutting discs determines
the cutting width. Without distance plates (only with reduction ring) the cutting width
is 8 mm. The set of distance plates contains the following distance plates:
1 Spacing washer
2 Spacing washers
1 Spacing washer
Arrow on diamond cutting discs must agree with arrow on protective hood cover-
direction of rotation.
7. Reassemble the tool (see above).
Loosen the wing nut and set the depth gauge
to the required depth. Loosen the wing nut
and set the depth gauge to the required
depth.
The cutting depth gets less as the diamond
cutting discs wear down.
In order to prevent edges from the remaining
cut strip breaking out, set the cutting depth
slightly deeper.
8
1 mm
2 mm
3 mm
Spanntec-
spindle
Spacing
washers
Reduction ring
Spanntec-nut
Round nut with drilled
holes in one face
WCE 65