SilverCrest SPM 200 A1 Mode D'emploi page 66

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

RP89212 Pasta Maker LB2 Seite 64 Mittwoch, 29. Mai 2013 11:35 11
If the defect is covered by our warranty, the
repaired product or a new one will be sent
back to you. There is no new warranty
period following repair or replacement of
the product.
Warranty period and statutory claims
relating to defects
The warranty period is not extended when a
service is provided under warranty. This also
applies to replaced and repaired parts. Any
damage or defects present at purchase must
be reported immediately the product is
unpacked. Repairs incurred once the warranty
period has expired are chargeable.
Scope of warranty
The
product
has
manufactured in accordance with strict
quality guidelines and was thoroughly
checked before being delivered.
The warranty applies to defective materials
or workmanship. This warranty does not
extend to product parts exposed to normal
wear and tear (and which can therefore be
considered wear parts) or to damage to
fragile parts such as switches, batteries or
parts made of glass.
This warranty is void if the product is
damaged or if it is not used or maintained
properly. All the information in the operating
instructions should be observed precisely to
ensure that the product is used properly.
It is essential to avoid intended uses and
actions which are discouraged or warned
against in the operating instructions.
The product is intended for only private use
and not for commercial purposes.
The warranty is void in the event of misuse,
incorrect treatment, use of force or
interference by anyone other than our
authorized service centre.
64
Warranty process
Please follow the instructions below to
ensure that your claim is processed quickly.
• In case of any enquiry, please keep the
• The article number can be found on the
• If malfunctions or any other defects
• Once a product has been recorded as
been
carefully
article
number
(for
IAN 89212) and the till receipt as proof
of purchase.
rating plate, as an engraving, on the
cover sheet of your instructions (bottom
left) or as a label on the back or
underside of your appliance.
should occur, in the first instance contact
the Service Centre mentioned below by
telephone or e-mail.
defective, you can then send it Freepost
to the service address you are given,
enclosing the proof of purchase (till
receipt) and quoting what the defect is
and when it occurred.
You
can
download
instructions and many other
manuals, product videos and
software from
www.lidl-service.com.
this
product:
these

Hide quick links:

Publicité

Table des Matières
loading

Table des Matières