SilverCrest SPM 200 A1 Mode D'emploi page 58

RP89212 Pasta Maker LB2 Seite 56 Mittwoch, 29. Mai 2013 11:35 11
5. Take off lid 1.
Note: There are two lugs on the front
edge of the lid. Pull these forward
slightly, lifting lid 1 as you do so, lift it up
and then take it off.
6. Turn screw housing 9 anticlockwise and
remove it.
7. Remove screw 11 from screw housing 9.
8. Take screw ring 10 off
screw 11.
9. Take kneader 8
compartment 6.
10.Take toothed
sleeve 7 off
kneader 8.
11. Take dough compartment 6 off motor
housing 3.
6.2 Assemble appliance
1. Put dough compartment 6 in motor
housing 3.
2. Push screw ring 10 onto
screw 11. Make sure that
the screw ring engages
correctly.
56
3. Put screw 11 in screw housing 9.
4. Push kneader 8 onto the shaft of
Note:
screw 11 has a notch, A,
with
kneader 8 only fits in one
position.
5. Push toothed sleeve 7 onto the shaft of
6. Push screw housing 9 assembled with
out of dough
Note: On the inside of
screw housing 9 is an
extension B which has to
face upwards when put in
so that screw housing 9
can be latched correctly.
7. Push screw housing 9 gently against
8. Check that dough compartment 6 is
9. Hold lid 1 at an angle and guide it into
10.Push lid 1 down until it is correctly
screw 11.
The shaft of
the result that
screw 11.
Note: The shaft of screw 11 has a
notch, with the result that toothed
sleeve 7 only fits in one position.
screw 11 and kneader 8 into dough
compartment 6.
dough compartment 6 and latch it by
turning it clockwise until it engages.
correctly located in motor housing 3.
lid locator 2 .
located on dough compartment 6 and
audibly engages.
Note: The safety switch which allows
the appliance to operate is activated
only if the lid is correctly engaged.
A
B