Technical Data - Beta 680/2,5 Mode D'emploi

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
Always use the following personal protective equipment:
• safety footwear;
• eye protection.
DYNATESTER USE AND CARE
• Do not subject the Dynatester to voltage overloads, and check that it is free from defects.
• Do not apply a torque higher than the maximum permissible torque.
• Do not allow persons unfamiliar with these instructions to operate the Dynatester.
• Do not modify the Dynatester. This can reduce the effectiveness of safety measures and
increase operator risk.
• Have the Dynatester repaired only through a trained repair person and only using original
replacement parts.
• To clean the Dynatester, use a dry cloth. Always disconnect the Dynatester from the power
supply mains before cleaning it. Never use damp or wet cloths.
• Periodically check the power supply cable of the Dynatester.
• Do not use the Dynatester if it is damaged or if it is not working properly. Do not try to open or
modify it, because electric shocks may occur.
• Connect the power supply cable to the mains socket, checking that the mains voltage matches
the voltage stated on the power supply device (see TECHNICAL DATA table).
• Unplug the Dynatester when not in use.
PERSONAL PROTECTIVE EQUIPMENT TO WEAR WHILE OPERATING DYNATESTER
Failure to observe the following warnings may result in physical injury and/or disease.
ALWAYS WEAR SAFETY SHOES
ALWAYS WEAR EYE PROTECTION

TECHNICAL DATA

NOMINAL POWER SUPPLY VOLTAGE
POWER SUPPLY OUTPUT VOLTAGE
ABSORPTION
DISPLAY
TORQUE MEASURING RANGE
ACCURACY
RESOLUTION
FEMALE SQUARE DRIVE
DIMENSIONS
SELECTABLE UNITS OF MEASUREMENT
OPERATING TEMPERATURE
STORAGE TEMPERATURE
WEIGHT
8
100 - 240V ~ 47/67Hz
9V CC
1.8 W max
4 digits
15 ÷ 400 N.m
± 1%
0.1°
1/2"
145 x 145 x 85 mm
N.m, lbf.ft, lbf.in
5°C ÷ 40°C
-20°C ÷ 70°C
4.0 kg
EN I