Beta 680/2,5 Mode D'emploi page 8

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
• safety footwear;
• eye protection.
DYNATESTER USE AND CARE
• Do not subject the Dynatester to voltage overloads, and check that it is free from defects.
• Do not apply a torque higher than the maximum permissible torque.
• Do not allow persons unfamiliar with these instructions to operate the Dynatester.
• Do not modify the Dynatester. This can reduce the effectiveness of safety measures and
increase operator risk.
• Have the Dynatester repaired only through a trained repair person and only using original
replacement parts.
• To clean the Dynatester, use a dry cloth. Always disconnect the Dynatester from the power
supply mains before cleaning it. Never use damp or wet cloths.
• Periodically check the power supply cable of the Dynatester.
• Do not use the Dynatester if it is damaged or if it is not working properly. Do not try to open or
modify it, because electric shocks may occur.
• Connect the power supply cable to the mains socket, checking that the mains voltage matches
the voltage stated on the power supply device (see TECHNICAL DATA table).
• Unplug the Dynatester when not in use.
PERSONAL PROTECTIVE EQUIPMENT TO WEAR WHILE OPERATING DYNATESTER
ALWAYS WEAR SAFETY SHOES
ALWAYS WEAR EYE PROTECTION
8
EN I