Eaton Crouse-Hinds Serie Instructions De Montage page 2

4. Assemble shim covered conductor
and end of strain relief wire into cable
hole. Strain relief ends should not be
inserted under the set screw of the
contact. Tighten set screw to 50-60
in-lbs. of torque. Set screws must be
below surface of contact to clear
plastic ring inside of sleeve.
5. Place contact against a firm surface
and push insulator over contact. Rivet
on contact must line up with slot in
plastic ring inside of sleeve. Slot is
under rib on sleeve. Rotate contact if
necessary to align rivet. Male should
be inside the insulator approximately
11/32"; female should be inside the
insulator about 1/8". Use male
contact to assemble female
connector. Use female contact to
assemble male connector.
NOTE
: Com-a-long assembly tools are
available for assembly if desired. Consult
factory for part numbers and prices.
Eaton.com/recycling
All manuals and user guides at all-guides.com
Crouse-Hinds Molded Products
UNITED STATES:
4758 Washington Street • La Grange, North Carolina 28551
Phone: (252) 566-3014 • FAX (252) 566-9337 • FSCM 90129
CANADA
:
Crouse-Hinds Canada
5925 McLaughlin Road • Mississauga, Ontario Canada L5R 1B8
Phone: (905) 507-4187 • FAX (905) 501-4078
EB 88
Page 2 of 2