Manuels Connexes pour aldes DESIGN Serie
Sommaire des Matières pour aldes DESIGN Serie
- Page 1 Residential ventilation DESIGN, DECO, IN LINE Axial fans Selection guide Design Deco In Line Deco Design installation In Line installation...
- Page 2 Axial fans SELECTION GUIDE Residential ventilation DECO Alu DECO DESIGN IN LINE* Installation In duct Ceiling or wall * For use with a decorative grille Surface of room to ventilate or diameter of fan < 7 m² from 7 to 12 m² >...
- Page 3 Axial fans DESIGN Advantages Compliance • Ultra-flat design. • CE electrical safety. • Silent from 26 dB(A). • WEEE recycling. • Very low power consumption : from 5.6 W. • Available with occupancy detection. • Exists in Ø 100, 125 and 150 mm Design Design P DIMENSIONS (mm) - WEIGHT...
- Page 4 Axial fans DECO Advantages Compliance • Aesthetic and discreet. • CE electrical safety. • Silent from 26 dB(A). • WEEE recycling. • Very low power consumption : from 5.6 W. • White or aluminium finish. FIELD OF APPLICATION DIMENSIONS (mm) - WEIGHT •...
- Page 5 Axial fans IN LINE Avantages Compliance • Silent. • CE electrical safety. • Air exhaust or air supply. • WEEE recycling. • No fan in the room (fitted in the duct). FIELD OF APPLICATION DIMENSIONS (mm) - WEIGHT • Intermittent ventilation of a room. Ø...
- Page 6 Axial fans DESIGN - DECO / DECO ALU INSTALLATION 1- Installation 2- removable backdraft damper • Connection diameter: Ø 100/125/150 mm (depending on model). DESIGN DECO DECO Alu • Fitted using 4 screws (supplied). • Wall or ceiling-mounted (fastening screws and plugs supplied). •...
- Page 7 Axial fans DESIGN - DECO / DECO ALU 5- Electrical connection and operation 1• Manual operation Immediate On/Off control using switch S. DECO DECO Alu 2 • Timed operation The extractor fan is activated using the switch S. Once turned off, the fan continues to operate for the time specified on the timer, between 2 and 30 minutes. DECO T DECO T Alu 2min...
- Page 8 Axial fans DESIGN - DECO / DECO ALU INSTALLATION 5- Electrical connection and operation (cont.) 3• Humidity-controlled operation The axial fan is activated using the switch S or when the humidity level H, pre-set between 60% and 90%, is exceeded. Once the fan is turned off or when the humidity level drops below the threshold, it continues to operate for the DESIGN H DECO H...
- Page 9 Axial fans DESIGN - DECO / DECO ALU 6- Fresh air intake • Requires an air inlet terminal (with air passage S) or a door undercut (height H). Ø 100 mm 100 cm 1 cm 125 mm 200 cm 2 cm 150 mm 250 cm 3 cm...
- Page 10 Axial fans IN LINE INSTALLATION 1- Installation 2- Installation on wall or ceiling • Installation inside a duct. • Maximum temperature of exhaust air: 40 °C • Requires an air inlet terminal or door undercut for correct ventilation of the room. d ≤...
- Page 11 Axial fans IN LINE 6- Fresh air intake • Requires an air inlet terminal (with air passage S) or a door undercut (height H). Ø 100 mm 100 cm 1 cm 125 mm 200 cm 2 cm 150 mm 250 cm 3 cm 7- Authorised installation locations •...
- Page 12 • Multiple operating modes. ■ AlDES AÉRAulIQuE - Headquaters: Tel : +33 4 78 77 15 15 - Fax: +33 4 78 76 15 97 ■ ALDES INTERNATIONAL - Tel: +33 4 78 77 15 34 - Fax: +33 4 78 77 15 56...