15. TROUBLESHOOTING
PROBLEM
The appliance does not
turn on
Does not dispense steam
Steam is weak or intermit-
tent.
The product leaves too
much water on the floor
Floor marked/dirty
If problems persist or are not listed above, please contact a Polti Authorised Service Centre
(www.polti.com for the updated list) or contact Customer Services.
All manuals and user guides at all-guides.com
CAUSE
No power
Power/adjustment dial in
the OFF position.
Boiler out of water
Appliance turned off.
Steam adjustment dial
set to the minimum.
Steam adjustment dial
set to the maximum.
Dirty cloth
| 23 |
SOLUTION
Check that the appliance has been
disconnected from the mains, as
indicated in Section 2.
Turn the power/adjustment dial to
one of the three steam-adjustment
settings.
Disconnect the appliance from the
mains, fill the water tank and wait
about 30 seconds.
Switch on the appliance by turning
the power/adjustment dial to one
of the three steam-adjustment set-
tings.
Increase the steam by turning the
power/adjustment dial to a higher
setting.
Reduce the quantity of steam to
the minimum. If necessary, mo-
mentarily stop the disbursement
of steam, while continuing to rub
the surface.
Clean the floor again, changing the
cloth.