Publicité
Les langues disponibles
Les langues disponibles
4. Installation
4.1 Mounting (Rack)
Mount your equipment in either a 4-post or 2-post rack or rack enclosure. The user must
determine the fitness of hardware and procedures before mounting. If hardware and procedures are
not suitable for your application, contact the manufacturer of your rack or rack enclosure. The
procedures described in this manual are for common rack and rack enclosure types and may not
be appropriate for all applications.
4-Post Mounting
1
The included plastic pegs
permanent mounting hardware is prepared. Insert a peg into the third hole from the top on the
front end of each bracket. On the rear end, insert a peg into the center hole. (Each front
bracket has 6 holes and each rear bracket has 5 holes.) The pegs will snap into place.
After installing the pegs, expand each shelf to match the depth of your rack rails. The pegs will
fit through the square holes in the rack rails to support the shelves. Refer to the rack unit
labels to confirm that the shelves are level in all directions.
Note: The support ledge of each shelf must face inward.
1
2
Remove the pegs at the front end of each bracket. Secure the shelves
permanently using the included screws and cup washers
front of each rail (4 total) and 2 screws at the back of each rail (4 total). Tighten all screws
before proceeding.
Note: The rear pegs may be left in for installation, but the front ones must be removed before the bracket is
secured by screws.
WARNING!
Do not attempt to install the UPS until the required screws have been inserted and
tightened. The plastic pegs will not support the weight of the UPS.
C
2
18-09-247-933652.indb 4
All manuals and user guides at all-guides.com
will temporarily support the empty rackmount shelves
A
A
B
B
4
B
A
B
to the mounting rails
C
as shown. Place 2 screws at the
C
2/13/2019 3:27:25 PM
while the
Publicité
