Wolf Garten GT 840 Mode D'emploi page 15

Operation
Working angle and wheels
• Free trimming
Working angle 1
Free trimming is especially suitable for
trimming large areas with high weeds or
grass. During free trimming, you should
swing the trimmer in a semi-circular
motion in front of your body.
- Set working angle
• trimming
Working angle 2 (no Fig.)
Recommendation: In order to achieve
an even and clean cut, you should use
the wheels (see ccessories).
• Trimming under bushes / on slopes
Working angle 3
- Set working angle
• Edge function (horizontal cut)
Working angle 4
The edge function enables precise and
convenient trimming along the edge of
the lawn.
1. Turn cutting head 90°
2. Set handle angle
Recommendation: In order to achieve an
even and clean cut, you should use the
wheels (see ccessories).
Maintenance
Replacing the cord spool
The trimmer continues to spin after
being switched off! lways disconnect
from the power supply before perform-
ing any work on the trimmer!
1. Press both locking tabs of spool cover
simultaneously and remove
2. Remove cord spool
3. Clean, if necessary
All manuals and user guides at all-guides.com
D
.
B
D
.
C
E
.
D
.
K
Telescoping handle (only GT 840) and grip
The trimmer is adjusted to your body height
by means of the telescoping handle and the
F G
middle grip
Insert power cable into cable holder
The power cable holder in the guide grip
prevents accidental disconnection of the
extension cable
On / off switch J
Tips on trimming
• Cut high grass slowly, step by step.
• If the cutting cord becomes too short
due to normal wear, simply switch off
the trimmer. The cord will then automati-
cally adjust to the correct length.
• Whenever the trimmer is switched off
and then on again, the cord automatically
lengthens 6-8 mm. If the trimmer is fre-
quently switched on and off for no reason,
this will increase wear of the cord.
• You can prolong the life of your trimmer
by removing grass from the ventilation
slots and the bottom of the trimmer be-
fore or after each use.
lways disconnect from the power
supply before performing any work
on the trimmer!
4. In order to prevent accidental unwinding,
do not remove the cord ends of the new
cord spool from the slits before insert-
ing the spool
5. Insert cord spool into housing
3 The bumps on the cord spool must
face the cover!
6. Place the spool cover on the cord spool
holder so that the two locking tabs lock
into place.
Before switching on: Hold trimmer parallel
to the ground; otherwise, there is danger
of injury.
.
H
.
L
M
.
15