Wolf Garten GT 840 Mode D'emploi page 14

Safety instructions
3. Cable
• Please work with safety cables. For the
connection only lines which are not lighter than
rubber hose lines H07 RN-F with a minimum
diameter of 3 x 1,5 mm² must be used.
• They must be waterproofmobile decvices that
are used outdoors must be connected via a
residual current circuit breaker.
• Use a leakage-protective system (RCD) with a
leakage current of no more than 30 m .
• ttach connection cable to traction relief.
Make sure that in does not rub against edges,
pointed or sharp objects. Do not squeeze
cable through door or window gaps.
• Switching devices must not be removed or
bridged (e.g. tying of switching lever to guide
spar).
4. Working
• lways keep hands and feet well clear of the
cutting mechanism, particularly when starting
the unit.
• void injury from each of the components
which serve to cut the line length. fter pulling
out a new length of line, always hold the unit in
its normal operating position before starting it.
• When starting the trimmer hold its base
parallel to the lawn area in order to avoid
accidents.
• Keep your hands away from the moving cord.
• Wear eye protection!
• lways wear appropriate working clothes and
sound footwear when using the trimmer.
• Before carrying the trimmer to the next lawn
area to be cut, switch it off.
• Be careful when you go backwards. You may
stumble!
• Keep the cable away from the cutting tool.
• Should the powercord be damaged during
use, immediately disconnect it from the mains.
Operation
Operating times
Please check noise abatement
regulations prevailing in your country.
14
All manuals and user guides at all-guides.com
Do not touch the cable until it has been
disconnected from the mains.
• Never leave the trimmer without supervision.
Store it in a safe place.
• The switches installed shall not be removed or
bridged over, e. g. by binding the switch to the
handle.
• Do not allow the cord spool to strike the
ground or edges of working area. If the cord
spool receives a hard knock, this will cause a
strong vibration on the handle. If this occurs,
the trimmer should be checked by a qualified
service centre.
5. fter operating
• fter using the unit, disconnected the power
cord from the wall outlet and inspect the unit
for damage.
• When switching off the trimmer: ttention: the
cutting tool does not stop immediately!
• lways wait for the cutting tool is stop.
• Before examining or cleaning the tool or
before removing the safety device or the cord
spool, switch off and disconnect the trimmer
from the mains. Only use original WOLF cord
spools and note the installation instructions!
• The cutting knife should not be cleaned under
running water or under high-pressure.
• Faults shall only be repaired by appointed
service centres or by the manufacturer.
• Make sure all air holes are free of dirt.
• Do not store the unit within reach of children.
6. Disposal
• Do not dispose of electrical equipment
in domestic waste. Recycle equipment,
accessories and packaging in an
environment-friendly manner.
Settings
The lawn trimmer is equipped with a
four-position adjustable working angle.
This enables you to easily trim hard-to-
reach areas in your garden.To set the
ideal working position, please follow the
instructions below.
3 The cutting head should be inclined
slightly for-ward while trimming.