Toshiba RAV-SM562UT-E Manuel Du Propriétaire page 11

ADJUSTMENT OF WIND DIRECTIONd
• When the air conditioner stops, the flap (adjustment plate of up/down wind direction) directs downward
automatically.
• When the heating operation is in READY states, the flap (adjustment plate of up/down wind direction) directs
upward. The swinging starts after HEAT READY status cleared, SWING
controller even if the heating operation is in READY status.
How to set up the wind direction
1
SWING/FIX
Push during operation.
The wind direction changes for every push of the button.
In HEAT operation
Direct the flap (adjustment plate of up/down wind direction) downward. If directing
at upward, hot air may not come to the foot.
In COOL/DRY operation
Direct the flap (adjustment plate of up/down wind direction) upward. If directing it
downward, the dew may from on the surface of the air discharge port and may
drop down.
How to start swinging
1
SWING/FIX
Push , set the flap (adjustment plate of
up/down wind direction) direction to the
lowest position, and then push
SWING is displayed and the up/down wind
direction is automatically selected.
How to stop swinging
1
Push SWING/WIND again while the flap is
swinging.
• The flap stops at a position when you push.
After then, if pushing
tion descends from the highest position.
• In COOL/DRY operation, the flap does not
stop as it directs downward. If stopping the
flap as it directs downward during swing
operation, it stops after moving to the 3
position from the highest position.
SWING/FIX
again.
SWING/FIX
, the wind direc-
rd
is displayed on the remote
TEMP.
TIMER SET
TIME
FILTER
RESET TEST SET CL
In FAN operation
Initial setup
Display when stopping the swing
Fan/Heat
operation
8
Initial setup
Initial setup
ON / OFF
FAN MODE
SWING/FIX VENT
UNIT
In all modes
Series of
operation
Cool/Dry
operation