Tripp-Lite SmartOnline Serie Guide De L'utilisateur page 5

Installation Important Safety Instructions
Connection and Start-Up (continued)
3 Turn the UPS ON:
• Press the ON/TEST Switch and hold it for
several seconds until you hear a beep
• Release the ON/TEST Switch. The ON
LINE LED will illuminate, and your UPS
will begin providing power to its AC outlets
Note: After initial installation of the UPS or after
prolonged storage, the internal batteries must charge for 2-
4 hours before the UPS can support connected equipment
during a power failure.
Optional Connections
Your UPS will function properly without these
connections.
Phone/Network Line
1
Suppression
Your
against surges on a telephone line or telephone/
network data line.* Using appropriate
telephone or network cords connect your wall
jack to the UPS jack marked "IN." Connect
your equipment to the UPS jack marked
"OUT." Make sure the equipment you connect
to the UPS's jacks is also protected against
surges on the AC line.
* Not compatible with PoE (Power Over Ethernet) applications.
Get user manuals: See SafeManuals.com
(continued)
UPS has jacks which
3
ACC. SLOT
protect
1
Your model may differ.
5
O
LOAD 1 LOAD 2
RS-232 USB
CAUTION
Risk of elec
See top of u
cautionary m
IN OUT EPO
PHONE / DATA PROTECTION